Langkah berjaga-jaga untuk pemasangan dan mesin ujian mesin peletup tembakan jenis cangkuk （（ € ï¼ ‰

Themesin peletup tembakan jenis cangkukumumnya mempunyai penampilan yang lebih besar, dan proses pemasangannya agak lebih rumit daripada peralatan kecil. Pemasangan dan mesin uji yang betul adalah kunci untuk memastikan operasi normal peralatan yang kemudian. Sekiranya terdapat operasi awal yang tidak mahir, pengguna diminta untuk mengikuti arahan kakitangan yang berkaitan dengan teliti atau merujuk kepada arahan tersebut. Operasi yang tidak dibenarkan boleh menyebabkan kerosakan yang tidak dapat dipulihkan dengan mudahmesin letupan cangkuk. Theshot blasting machine manufacturer has sorted out the precautions for installation and test machine to share with you. I hope it will be helpful to users who use the device for the first time.
1. Installation. Themesin peletup tembakan jenis cangkuk is installed and debugged in the production plant and disassembled into several parts before being transported to the user site for installation. Although there is no pit, the foundation must be firm, the anchor bolt holes must be standardized, and the chamber body must be adjusted. After the second irrigation, the anchor bolt nuts can be tightened after solidification. After the chamber body is fixed, the various parts can be installed. Theprecautions for the installation and debugging of the relevant components are introduced below.
1. Alat letupan tembakan:
Theshot blasting device has been installed on the chamber body before leaving the factory. Please pay attention to the problems to be debugged before use. Check whether the fixed positions of the blade, the pill wheel, the directional sleeve, and the guard plate are accurate and firm, and check whether the direction of rotation is correct after power on. Then adjust the position of the directional sleeve opening. Theoretically, the angle between the front edge of the directional opening and the front edge of the blade throwing position is about 900. After fixing the position of the directional sleeve, the position of the projectile belt can be detected by hanging Place a steel plate or wooden board on the position of the workpiece facing the exit of the shot blasting machine, start the shot blasting machine, put a small amount (2-5kg) of projectiles into the blasting tube, and then stop, check whether the hit position on the steel plate is suitable for the needs, such as Close the window of the bias-adjustable directional sleeve downwards, and vice versa, until it fits, and note the position of the directional sleeve opening as a basis for future replacement of the directional sleeve.
2. Penghantar gelung dan skru:
Mula-mula menjalankan ujian tanpa beban untuk memeriksa sama ada baldi pengangkut dan bilah spiral berjalan ke arah yang betul, kemudian ketatkan tali pinggang pengangkat ke tahap ketegangan yang sederhana untuk mengelakkan penyimpangan, dan kemudian lakukan ujian beban untuk memeriksa operasi dan kapasiti penyampaian, sama ada terdapat keanehan Kebisingan dan getaran, periksa dan hilangkan halangan.
3. Pemisah pil pasir:
Mula-mula periksa sama ada pergerakan ram fleksibel, dan kemudian periksa kedudukan plat pemisah yang betul, kemudian ketika pengangkat dimuat dan disahpepijat, terdapat aliran masuk tembakan berterusan, dan periksa sama ada tembakan keluli mengalir keluar dan jatuh semasa pelongsor dilepaskan